Genie GC-1530, Service Manual

Page: 126 / 270

January 2012 Section 4 • Repair Procedures
4 - 64 GS-30 • GS-32 • GS-46 • GS-47 Part No. 228901
48 Remove the cables from the number 2A and 2B
cable bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
49 Disconnect the number 2A and 2B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
50 Attach a lifting strap from an overhead crane to
the number 2 outer arm at the ground control
side (index #14).
51 Remove the retaining fasteners from the
number 2 center pivot pin (index #5) at the
ground control side.
52 Place a rod through the number 2 center pivot
pin at the ground control side (index #5) and
twist to remove the pin.
53 Remove the retaining fasteners from the
number 2 pivot pin (index #15) at the non-steer
end.
54 Use a soft metal drift to remove the number 2
pivot pin (index #15) from the non-steer end of
the machine. Remove the number 2 outer arm
at the ground control side (index #14) from the
machine.
Crushing hazard. The number 2
outer arm at the ground control
side (index #14) may become
unbalanced and fall if not properly
supported when the pivot pin is
removed.
55 Attach a lifting strap from an overhead crane to
the number 2 outer arm at the battery side
(index #14).
56 Remove the retaining fasteners from the
number 2 center pivot pin (index #5) at the
battery side.
57 Place a rod through the number 2 center pivot
pin at the battery side (index #5) and twist to
remove the pin.
Crushing hazard. The number 2
outer arm (index #14) may
become unbalanced and fall if not
properly supported when the pivot
pin is removed.
58 Remove the number 2 outer arm (index #14)
from the machine.
Crushing hazard. The number 2
outer arm (index #14) may
become unbalanced and fall if not
properly supported when removed
from the machine.
59 Attach a lifting strap from an overhead crane to
the number 2 inner arm (index #13). Raise the
arm to a vertical position.
60 Remove the retaining fasteners from the
number 2 pivot pin at the steer end of the
machine (index #6).
61 Use a soft metal drift to remove the number 2
pivot pin (index #6) from the steer end of the
machine. Remove the number 2 inner arm
(index #13) from the machine.
Crushing hazard. The number 2
inner arm (index #13) may
become unbalanced and fall if not
properly supported when the pivot
pin is removed.
62 Attach a lifting strap from an overhead crane to
the number 1 inner arm (index #8).
63 Raise the number 1 inner arm (index #8)
approximately 2 feet / 60 cm.
64 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x 1.2 m
long block across both sides of the chassis
under the number 1 center pivot pin (index #7).
SCISSOR COMPONENTS