Genie GC-1530, Service Manual

Page: 142 / 270

January 2012 Section 4 • Repair Procedures
4 - 80 GS-30 • GS-32 • GS-46 • GS-47 Part No. 228901
14 Remove the fasteners securing the large
platform height sensor bracket to the number 1
inner arm pivot bracket.
15 Remove the large platform height sensor
bracket from the number 1 inner arm pivot
bracket.
16 Install the fasteners removed in 14 to the
number 1 inner arm pivot bracket and chassis.
Tip-over hazard. Failure to install
the fasteners securing the number
1 inner arm pivot bracket to the
chassis, could result in the
machine tipping over, causing
death or serious injury.
17 Connect the battery pack to the machine.
18 Turn the key switch to the ground control
position.
19 Press and hold the ground control scroll up and
scroll down buttons.
20 Pull out the red Emergency Stop button to the
on position at the ground controls.
21 Using the ground control menu buttons,
navigate to Service Override Mode. Select
Service Override Mode.
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
22 Raise the platform and return the safety arm to
the stowed position.
23 Fully lower the platform to the stowed position.
Cable bridge and platform height sensor
legend
a cable bridge 5
b cable bridge 4A
c cable bridge 4B
d cable bridge 3A
e cable bridge 3B
f cable bridge 2A
g cable bridge 2B
h cable bridge 1
i platform height sensor
24 Remove the platform. See 10-1, How to
Remove the Platform.
25 Support and secure the entry ladder to an
appropriate lifting device.
SCISSOR COMPONENTS