Genie GC-1530, Service Manual

Page: 59 / 270

Section 3 • Scheduled Maintenance Procedures January 2012
Part No. 228901 GS-30 • GS-32 • GS-46 • GS-47 3 - 33
GS-2032, GS-2632, GS-3232, GS-2046, GS-2646,
GS-3246 and GS-4047:
1 Measure the distance between the number one
outer arm cross tube and the fork lift tube at the
ground controls side of the non-steer end of the
machine.
Result: The measurement is
0.88 inch / 22.4 mm or more. Proceed to step 2.
Result: The measurement is less than
0.88 inch / 22.4 mm. Replace both wear pads.
Refer to Repair Procedure 9-3, 9-4, 9-5 or 9-6,
How to Replace the Scissor Arm Wear Pads.
2 Measure the distance between the number one
outer arm cross tube and the fork lift tube at the
battery pack side of the non-steer end of the
machine.
Result: The measurement is
0.88 inch / 22.4 mm or more. Proceed to step 3.
Result: The measurement is less than
0.88 inch / 22.4 mm. Replace both wear pads.
Refer to Repair Procedure 9-3, 9-4, 9-5 or 9-6
How to Replace the Scissor Arm Wear Pads.
3 Apply a thin layer of dry film lubricant to the
area of the chassis where the scissor arm wear
pads make contact.
Cross tube to chassis specification
Measurement, minimum 0.88 inch
22.4 mm
a outer arm cross tube
b fork lift tube
c wear pad
CHECKLIST D PROCEDURES