AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016
33
Connecting SharpX cameras for a mobile installation
To use SharpX cameras for a mobile installation, there are multiple steps you must perform to
connect the camera.
Before you begin
Do the following:
• Ensure that you have
.
• Some of the connections require tension clamps. Make sure you know how to
.
• Position and install the horizontal or vertical bracket in the vehicle trunk, and then attach the
LPR Processing Unit to the bracket. Remember to consider the size of the LPR Processing Unit for
proper clearance and spacing. If you do not have the proper
required for your installation,
contact your Genetec representative.
What you should know
IMPORTANT
:
When connecting the camera cable, follow these guidelines:
• Do not tighten the connector by turning the camera cable.
• Do not turn the connector from behind the outer ring.
• Do not use any tools to tighten the connector.
CAUTION
:
A loose connector may cause water to leak into the SharpX camera. AutoVu SharpX
cameras are IP67 compliant only when the plastic protector cap is on, or when the cable is
connected to the camera according to the instructions.
IMPORTANT
:
Ensure that all electrical connections are insulated. This protects against accidental
electrical short-circuiting, both during and after the wiring installation process.
IMPORTANT
:
Do not use any "wire splice" type connectors (such as self-stripping electrical tap
connectors). Vehicle vibrations will cause these connectors to fail. Connections should be soldered
and shrink wrapped.
To connect the SharpX, refer to the illustration below, and the steps that follow:
