AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016
56
5 When installing the USB GPS, you also need to change the baud rate of the device to 4800. For
more information, refer to the Patroller Config Tool instructions in the
Patroller Administrator
Guide
.
To install the u-blox driver required to use the Wi-Sys WS3910 GPS antenna:
1 Turn on the in-vehicle computer and sign in to Windows using an Administrator account.
2 On the Patroller installation DVD, navigate to
Drivers\AutovuNavigator\u-blox GPS Receiver
, and
double-click the driver file.
3 Follow the on-screen instruction to complete the installation process.
Installing the magneto coil for rear wheel drive vehicles
The magneto coil is the recommended method for providing odometry information to Patroller. You
must install a magneto coil for AutoVu installations that include wheel imaging cameras.
What you should know
• In addition to the contents of the magneto coil kit, you will require epoxy to secure the magnets.
This step is recommended as tie straps can break over time.
• As an alternative to installing the magneto kit, you can connect to the vehicles VSS signal.
For rear wheel drive vehicles, you must install the magneto coil on the drive shaft, behind the
universal joint.
•
A
: Tapping screw
•
B
: Vehicle floor pan
•
C
: Blue and gray wires
•
D
: Magneto coil
•
E
: Mounting bracket
•
F
: Stamped nut
•
G
: Bolt
•
H
: Drive shaft
•
I
: Tie strap
•
J
: Magnet
