AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016
59
•
A
: CV joint
•
B
: Magnet
•
C
: Tie strap
•
D
: Magneto coil
•
E
: Stamped nut
•
F
: Blue and gray wires
•
G
: Transmission housing bolt
•
H
: Mounting bracket
To install the magneto coil for rear wheel drive vehicles:
1 Raise and safely support the vehicle so that you can work behind the front axle.
WARNING
:
Read the following warnings:
• Never get under any vehicle held up by a jack only. Use jack stands or ramps.
• Do not use concrete blocks to support a vehicle.
• Always chock the wheels of the vehicle and set the parking brake. Failure to follow safe jacking
procedures will endanger your life.
2 Bolt the magneto coil to the mounting bracket (or drive shaft guard) using the supplied 1-1/
2" (3.8 cm) bolt and stamped nut. Use silicon or other adhesive to lock the nut on the coil in place.
Tighten to 20-30 in-lbs torque.
IMPORTANT
:
Read the following important notices:
• Too much torque will damage the magneto coil.
• The wire end of the coil should be against the mounting bracket.
3 Find the best location to install the magneto coil. The distance between the coil bolt head and
the magnet that will be attached to the axle housing will need to be no more than 1/4" (0.64 cm).
