3
TS4000H
WARNING:
Silicone Room Temperature Vulcanization (RTV) is not an approved moisture
barrier. If used, damage to internal components will arise.
WARNING:
Substitution of electrical components within the TS4000H may impair intrinsic
safety.
WARNING:
Damage to the TS4000H housing where any internal components or protective
seals are broken, compromises the safety and usability of the device. A
TS4000H with a damaged or open housing should not be used in a hazardous
environment. Such damage includes fractures in the housing, cracks in any
internal components, or cracks in the protective seals. Destruction of the
electrochemical cell (ECC) will not affect the basic safety of the TS4000H;
however, the overall functionality of the TS4000H may be severely compromised.
WARNING:
Do not use a TS4000H with a damaged housing in a hazardous environment.
DO NOT OPEN WHEN AN EXPLOSIVE ATMOSHPERE IS PRESENT.
READ AND UNDERSTAND INSTRUCTION MANUAL BEFORE
OPERATING OR SERVICING. OPEN CIRCUIT BEFORE REMOVING
COVER. POTENTIAL ELECTROSTATIC CHARGING HAZARD – USE
ONLY DAMP CLOTH FOR CLEANING.
NE PAS OUVRIR UN PRÉSENCE D’ATMOSPHÉRE EXPLOSIVE. LIRE
ET COMPRENDRE MANUEL D’INSTRUCTIONS AVANT D’UTILISER OU
SERVICE. OUVRIR LE CIRCUIT AVANT D'ENLEVER LE COUVERCLE.
DANGER POTENTIEL ÉLECTROSTATIQUE DE CHARGE –
UTILISATION UNIQUEMENT UN CHIFFON HUMIDE POUR LE
NETTOYAGE.
IMPORTANT:
Each TS4000H is shipped with an un-installed electrochemical sensor, to
ensure that a fresh sensor is used during initial start-up.
DO NOT
install the
electrochemical cell into the TS4000H until you are ready to apply power to the
system. Since the TS4000H is not factory calibrated to a specific cell, an initial
field calibration must be completed when installing this unit.
SPECIAL CONDITIONS OF SAFE USE PERTAINING TO ATEX/IECEx INSTALLATIONS:
The TS4000H shall not be used as a Safety Related Device as defined by ATEX Directive
94/9/EC,
The Intelligent Sensor Toxic Gas Interface Module Type TS4000(H) shall be installed on a
suitably certified Flameproof or Increased Safety enclosure.
The Interface Module Type TS4000(H) shall not be used in an atmosphere that contains more
than 21% oxygen.
The Interface Module Type TS4000(H) input power to the equipment shall be limited to 1W.
The Interface Module Type TS4000(H) has a temperature rise of 10K/W and is suitable for use
with equipment having a temperature class of T5 in an ambient temperature of up to 75°C.
