TS4000H
40
The default settings for Channel 2 are:
Address 2
9,600 baud
8-N-1
To Adjust the Modbus Channel 2 Settings
1. Apply and hold the magnet on the GM logo on the Base Unit cover. Wait until “
SE
”
displays and then remove the magnet. This action places the unit into Setup Mode.
2. After a few seconds “
CH2
” displays. Apply and remove the magnet to select Channel 2.
The Channel 2 menu level headings are then displayed.
3. To select the Channel 2 baud rate, apply and remove the magnet when “
Br
” displays.
The current baud rate is then displayed. If another baud rate is to be selected, apply
and hold the magnet until the required baud rate displays, and remove to select the
required baud rate. The choices are:
19,200
baud
“
192
”
9,600 baud “
96
”
4,800 baud “
48
”
2,400 baud “
24
”
4. To select the Channel 2 data format, apply and remove the magnet when “
For
”
displays. The current format is then displayed. If another data format is required, apply
and hold the magnet until the required data format displays, and remove to select the
required data format. The choices are:
8-N-1
“
8n1
”
8-N-2
“
8n2
”
8-E-1
“
8E1
”
8-O-1
“
8o1
”
5. To select the Channel 2 address, apply and remove the magnet when “
Add
” displays.
The current address is then displayed. Apply and hold the magnet to increment the
address by 1.
6. Remove the magnet to select the currently displayed address. To save the setting,
apply and remove the magnet when “
Fi
” displays.
7. To exit the Setup Menu, apply and remove the magnet when “
Fi
” displays again and
return to normal operation.
4.6.6 HART/Modbus
SELECT
This option is not shown if HART was not purchased for the TS4000H. When HART is selected
via setup, the Modbus Channel 2 setup is not displayed or available. When Channel 2 is
changed from HART to Modbus, the previous Modbus Channel 2 settings are used. Refer to
Section 4.2 for User Menu Structure.
