Geneko GWR-I series, User Manual

Page: 41 / 113

USER MANUAL GWR-I Cellular Router Series
41
Alternative firmware version (Aggressive Mode supported)
IPSec Summary and IPSec Settings related with first firmware version are briefly displayed in
following figures and tables below
Figure 17 - IPSec Summary screen for first firmware version
VPN Settings / IPSec Summary
Label Description
Tunnels Used
This is the number of IPSec tunnels being defined.
Maximum number of
tunnels
This is the maximum number of tunnels which can be defined.
No
This filed indicates the number of the IPSec tunnel.
Name Field shows the Tunnel Name that you gave to the IPSec tunnel.
Enabled
This field shows if tunnel is enabled or disabled. After clicking on Start button,
only enabled tunnels will be started.
Status
Field indicates status of the IPSec tunnel. Click on Refresh button to see current
status of defined IPSec tunnels.
Enc/Auth/Grp
This field shows both Phase 1 and Phase 2 details, Encryption method
(DES/3DES/AES), Authentication method (MD5/SHA1), and DH Group number
(1/2/5) that you have defined in the IPSec Setup section.
Advanced
Field shows the chosen options from IPSec Advanced section by displaying the
first letters of enabled options.
Local Group
Field shows the IP address and subnet mask of the Local Group.
Remote Group Field displays the IP address and subnet mask of the Remote Group.
Remote Gateway Field shows the IP address of the Remote Device.
Delete Click on this link to delete the tunnel and all settings for that particular tunnel.
Edit This link opens screen where you can change the tunnel’s settings.
Add New Tunnel
Click on this button to add a new Device-to-Device IPSec tunnel. After you have
added the tunnel, you will see it listed in the Summary table.
Start
This button starts the IPSec negotiations between all defined and enabled tunnels.
If the IPSec is already started, Start button is replaced with Restart button.