Geneko GWR-I series, User Manual

Page: 31 / 113

USER MANUAL GWR-I Cellular Router Series
31
RIP Settings
Label Description
Routing Manager
Hostname Prompt name that will be displayed on telnet console.
Password Login password.
Enable log Enable log file.
Port to bind at Local port the service will listen to.
RIPD
Hostname
Prompt name that will be displayed on telnet console of the Routing
Information Protocol Manager.
Password Login password.
Port to bind at
Local port the service will listen to.
Routing Information Protocol Status
Start
Start RIP.
Stop
Stop RIP.
Restart
Restart RIP.
Save
Click Save to save your changes back to the GWR-I Router.
Reload Click Reload to discard any changes and reload previous settings.
Table 8 – RIP parameters
RIP routing engine for the GWR-I Router
Use telnet to enter in global configuration mode.
telnet 192.168.1.1 2602
// telnet to eth0 at TCP port 2602///
To enable RIP, use the following commands beginning in global configuration mode:
router#
router rip
To associates a network with a RIP routing process, use following commans:
router#
network
[A.B.C.D/Mask]
By default, the GWR-I Router receives RIP version 1 and version 2 packets. You can configure the
GWR-I Router to receive an send only version 1. Alternatively, tou can configure the GWR-I Router to
receive and send only version 2 packets. To configure GWR-I Router to send and receive packets from only
one version, use the following command:
router# rip version [1|2]
// Same as other router //
Disable route redistribution:
router#
no redistribute kernel
router#
no redistribute static
router#
no redistribute connected