Geneko GWR-I series, User Manual

Page: 102 / 113

USER MANUAL GWR-I Cellular Router Series
102
Figure 90 - IPSec tunnel between GWR-I Router and Cisco Router
The GWR-I Routers requirements:
•
Static IP WAN address for tunnel source and tunnel destination address;
•
Source tunnel address should have static WAN IP address;
•
Destination tunnel address should have static WAN IP address;
GSM/UMTS APN Type: For GSM/UMTS networks GWR-I Router connections may require a Custom
APN. A Custom APN allows for various IP addressing options, particularly static IP addresses, which are
needed for most VPN connections. A custom APN should also support mobile terminated data that may be
required in most site-to-site VPNs.
The GWR-I Router configuration:
•
Click
Network
Tab, to open the
LAN NETWORK
screen. Use this screen to configure LAN TCP/IP
settings. Configure IP address and Netmask.
-
IP Address: 192.168.10.1
- Subnet Mask: 255.255.255.0
- Press Save to accept the changes.
Figure 91 - Network configuration page for GWR-I Router
•
Use SIM card with a static IP address, obtained from Mobile Operator.
•
Click WAN Settings Tab to configure parameters necessary for GSM/UMTS connection. All
parameters necessary for connection configuration should be required from mobile operator.
•
Check the status of GSM/UMTS connection ( WAN Settings Tab). If disconnected please click
Connect button.