918196/EP0913
3-10
Printed in U.S.A.
Tilting the Cab or Canopy
Refer to items 1-11 in Figure 3-13 to safely complete
the following procedure.
Tilting the cab or canopy up:
1. Follow “Mandatory Safety Shutdown Procedure”
on page 2-2.
2. Raise the floor mat (1) on the right, front of the cab
and remove cab lock-down nut (2). Remove cab
lock-down bolt (3) at the right rear of the cab.
3. Securely close the cab door.
4. Locate the jack handle tubes (4) from the tool kit in
the engine compartment, insert them into the jack
(5) and extend the jack as far as it will go. The cab
will be raised as far as the jack (5) will travel.
5. Pull on handle (7) until the cab is completely tilted
and supported by the safety cable (8).
6. Remove the tilt support (9) from the storage
bracket (10) and slide the tilt support into the guide
bracket (11) and secure with the retention pin.
Tilting the cab or canopy down:
1. Remove the tilt support (9) from the guide bracket
(11) by removing the retention pin and slide the tilt
support out of the guide bracket. Secure the tilt
support into the storage bracket (10). Replace the
retention pin back into the guide bracket for stor-
age.
2. Use handle (7) to slowly lower the cab back onto
the jack.
3. Remove jack handle tubes (4) from the jack and
insert the opposite end of the jack handle tubes
onto the release pin (6). Slowly twist the release
pin counter-clockwise until the cab is lowered.
4. Turn the release pin (6) clockwise.
5. Reinstall the cab lock-down nuts (2) and (3).
6. Place the jack handle tubes (4) back in the tool kit.
Figure 3-13 Tilting the cab or canopy
WARNING
•
Always tighten cab lock-down nuts
before driving or using the machine.
•
Always close the cab door before tilting
the cab.
•
Stay clear from underneath the cab as it
is tilted.
•
Always secure the tilt rod in the support
position when the cab is tilted.
CAUTION
Check the tilt support (9), retention pin (11)
and safety cable (8) at regular intervals for
cracks and cuts. Replace defective parts
immediately.
2
1
3
4
5
7
8
6
9
11
10
Summary of Contents for 383Z
