Gehl 383Z, Operator'S Manual

Page: 58 / 112

918196/EP0913 3-16 Printed in U.S.A.
MACHINE OPERATION
Pre-Operation Checklist
Check the following items at the beginning of each
work day or every 12 working hours:
•
Seat belt and mounting hardware
• Safety decals (replace as required)
• Air cleaner and intake hoses
• Engine coolant level and system for leaks
• Clean engine area of any flammable materials
• Engine oil level (Fill if required)
• Water drained from fuel pre-filter
• Hydraulic system for leaks
• Hydraulic fluid level (Fill if required)
• Pivot points lubricated and operating properly
• Track tension
• Windshield washer reservoir level (if cab installed)
• Broken and/or loose parts (Repair as required)
• Left armrest down in operating position
• Attachment safely locked on machine
• Engine cover closed
• Fuel level
Engine Start and Stop
Note: When all machine controls are stationary (no
pilot control pressure), the swing motor and travel
motor brakes are automatically applied. When any
control is activated, the appropriate brake is automati-
cally released.
Note: All hydraulic functions are locked out when the
operator’s seat left console is in the raised position.
WARNING
• Read and understand this entire man-
ual. Follow warnings and instructions
for operation and maintenance. Failure
to follow instructions can result in injury
or death.
• Read and understand all safety decals
before operating the machine. DO NOT
operate the machine unless all factory
installed guards and shields are in
place.
• Be sure you are familiar with all safety
devices and controls before operating
the machine.
• Know how to stop the machine before
starting.
• Use only with approved accessories or
referral attachments. Manitou Ameri-
cas, Inc. cannot be responsible for
safety if the unit is used with non-
approved attachments.
• Check for correct function after adjust-
ments or maintenance.
IMPORTANT
See the table of recommended lubricants in
“Fluid Capacities/Lubricants” on page 1-4
for the proper engine and hydraulic oil
specifications. Only use lubricants speci-
fied in the table.
IMPORTANT
Do not completely drain the fuel tank while
running the excavator. If this happens, air
will enter the fuel system, and the fuel sys-
tem will have to be bled. Always completely
fill the tank with fuel at the end of the work-
ing day.
WARNING
Never use ether starting aids. Glow plugs
are used for cold weather starting. The glow
plug can cause ether or other starting fluid
to detonate, causing injury.