Printed in U.S.A.
3-15
918196/EP0913
To close the windshield, re-install the lower windshield
(if removed), and squeeze/turn the latches, and then
lower the windshield and lock the latches in the closed
position.
Cab Door Latch Release
When fully opened, the left cab door will latch in posi-
tion to the side of the cab. To release the latch, use the
knob (1) located on the inside of the door frame. See
Figure 3-23.
Figure 3-23 Cab Door Latch Release
Interior Light
The interior light is located on the back of the cab
above the rear window. Press the switch to the right or
left to turn the light ON. Move the switch to the center
position to turn the light OFF.
Figure 3-24 Interior Light
Cab Heat Control (cab only)
During the colder months, the operator’s cab heater can
be operated using the heater control (1, Figure 3-25) on
the right of the kick plate below the operator’s seat.
Rotate the control clockwise to reduce the heat; coun-
ter-clockwise to increase the heat.
Recirculated Air Mode (cab only)
When heating or cooling the cab, the recirculated air
mode heats or cools using only air from inside the cab
and not air from outside the cab. Sliding the plate to the
left will turn OFF the recirculated air mode by closing
the vent (Figure 3-25). Sliding the plate to the right will
turn ON the recirculated air mode by opening the vent.
Figure 3-25 Recirculated Air Mode/Heater Con-
trol
Tool Kit and Cab Jack Handle
The machine tool kit and the cab jack handle are
located in the storage area under the hood in the engine
compartment.
CAUTION
Support the windshield when releasing it
from the ceiling catches to avoid possible
head injury.
1
ON
OFF
1
Summary of Contents for 383Z
