– 14 –
(
Continued next page
)
STEP 9 REVERSE DOOR SWING
(cont)
.
14.
install screws on the bottom hinge next .
15.
Using a Torx T-20 wrench, tighten the tension on
the hinge springs by turning the screws from
0
to
|
.
13.
With another person holding the door in place,
align the holes in the door hinge bracket with the
holes in the hinge. Install the screws to the top
hinge f irst .
Door
Screws
Use Torx
T-20 Wrench
STEP 10 ADJUST DOOR SWING
(if needed)
NOTE:
This refrigerator has a 2-position door stop. When
space does not allow the door to swing to 115°, you may
limit the door swing to a 90°
Skip this step if door opening is satisfactory for your
installation situation.
• Open the fresh food door to access the top and bottom
hinges.
• Loosen the bottom hinge screws that attached to the
unit
• Pull hinge forward slightly & insert hinge pin into the
hole nearest the unit .
• You may need to use a small hammer to fully seat
them in place.
• Retighten hinge screws.
• Repeat for top hinge.
Install 1 pin,
per hinge for
90° door stop.
Hinge screws
STEP 11 ATTACH HINGE GUARD
WARNING:
This appliance must be installed & operated with the
hinge guard in place !
1.
Attach hinge guard by sliding flat part between case
and adjacent cabinetry.
2.
Fasten guard to door front using 4 screws.
STEP 12 INSTALL DOOR AND DRAWER
PANELS
1.
Remove all door and drawer hooks from the unit and
screw them to the custom panels, aligning them with the
lowest set of predrilled holes for Monogram Panel Kits on
the FF door panel.
2.
Attach top L-Bracket to FF panel.
3.
If you had custom handles made and they are not
currently attached to your panels, do so now.
4.
Open the fresh food door to attach the fresh food panel.
5.
Slide the hooks on the fresh food panel into the slots of the
door, and lower the hooks into place. Make sure the
bracket on the top of the panel slides over the screw posts
on top of the door. The brackets will rest on top of the nuts.
Slots
Hooks
Screw Post
Bracket
Hooks on the Freezer
drawer panel face up.
