– 38 –
8. Remove the 8 Phillips-head screws on the lower
cover.
Lower Cover
Disconnect
Wall Heater
11. Remove the lower cover from the cabinet.
12. Remove the four Phillips-head screws from the
upper cover.
13. Remove the upper cover from the cabinet.
Upper Cover
9. Pull the right side of the lower cover out to
expose connections on the left side.
10. Disconnect the wall heater wire harness and
remove the 7-mm hex nut, 2 lock washers, and
ground wire from the left side of the lower cover.
Disconnect
Disconnect
Damper
Damper
16. Using a small,
fl
at blade screwdriver, press in the
release tab and disconnect each freezer damper
wire harness.
17. Remove the Styrofoam evaporator cover.
14. Remove the 2 Phillips-head screws and the 2
metal cover retainers from the Styrofoam cover.
Caution:
The Styrofoam evaporator cover contains
2 dampers that control the upper and lower cooling
zone temperatures. In the following step, to prevent
damage to attached damper wiring connectors,
care must be taken when removing this cover.
15. Pull the bottom of the cover out from the
evaporator drain channel and tilt it up at an
angle to access the damper wiring at the top.
Cover Retainers