GE XDP-H2, User Manual

Page: 48 / 96

Setup and Calibration 4-19
January 2008
Versions
To view the current software versions installed in your meter, access
the main menu as described on page 3-4, and proceed as follows:
Note:
The “User” menu option is also available above.
The following software information is listed in the above display:
•
Slot 0: controller main circuit board software
•
Slot 1: XDP circuit board software
•
Slots 2-4: not normally used for the XDP
Note:
The versions of the software installed in Slots 1 and 2 at the
above prompt are used only as an example. The actual
versions of your software will appear instead.
Press
[ESC]
until you exit the User Program , or proceed to the
appropriate section of this chapter to continue programming the
meter.
Cal Opt Disp Use the [
W
] and [
X
] keys to
select
[Opt]
and press
[ENTER]
.
Cal Opt Disp Use the [
S
] and [
T
] keys to
select
[Versions]
and press
[ENTER]
.
Lock Menus
Lock All
Versions
Versions After noting the software ver-
sion data, press
[ENTER]
.
0:BSERIES.STD.001.0
1:XDP.H2G.001.B
2:
Cal Opt Disp Press
[ESC]
to return to the
main menu.
Lock Menus
Lock All
Versions