GE Multilin MM300, Instruction Manual

Page: 45 / 198

CHAPTER 2: INSTALLATION STARTER TYPES
MM300 MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL 2–25
Figure 2-29: Full-voltage non-reversing starter control wiring - IO_E
NOTE
NOTE:
The above drawing applies only to a high-voltage power supply. If a low-voltage (DC)
power supply is used, an appropriate DC voltage source must be used for this power
supply.
.
The full-voltage non-reversing starter type is a full voltage or across-the-line non-reversing
starter.
When a start control is received, the pre-contactor relay (if any) is picked up for the set pre-
contactor time. When the pre-contactor timer times out, relay1 picks up and seals-in,
picking up contactor M, which starts the motor. When a stop control is received, relay1
drops out, contactor M drops out, and the motor stops. The pre-contactor is omitted on
forced starts (for example, UVR Immediate, External Start).
NOTE
NOTE:
Connect AUX VT to the Control Supply for correct operation of the UV Restart feature and
correct input readings.
M
M
Field Stop
Field Start
Reset
MM300
Low Voltage
Motor
Manager
PSU
C1
C2
C3
C4
C5
C6
C7
C8
I/O
M
od
ule-
T
y
pe
C
C9
C10
C11
C12
C13
C14
Au
x
VT
N
L
IN
1
IN
2
IN
3
IN
4
IN
5
IN
6
Co
m
Re
la
y
1R
el
a
y
2
L
N
GE Multilin
853704B3.cdr
Low Voltage
DC Suppl
y
to
IO T
y
pe E
+
-
AC
Control Power
G