GE MDS Mercury Series, Reference Manual

Page: 63 / 196

05-4446A01, Rev. C Mercury Reference Manual 55
•
Trap Version
—This specifies which version of SNMP is used to
encode the outgoing traps. The choices are
v1_traps
,
v2_traps
,
and
v3_traps
. When
v3_traps
is selected, v2-style traps are sent,
but with a v3 header. [
v1_traps, v2_traps, v3_traps
]
•
Auth Traps Status
—Indicates whether or not traps are generated
for failed authentication of an SNMP PDU. [
Disabled/Enabled;
Disabled
]
•
SNMP V3 Passwords
—Determines whether v3 passwords are
managed locally or via an SNMP Manager. The different behav-
iors of the Agent, depending on the mode selected, are described
in
SNMP Mode
above.
•
Trap Manager #1–#4
— Table of up to four locations on the net-
work to which traps are sent. [
Any standard IP address
]
NOTE:
The number in the upper right-hand corner of the screen is the
SNMP Agent’s SNMPv3 Engine ID. Some SNMP Managers
may need to know this ID in order interface with the trans-
ceiver’s SNMP Agent. The ID only appears on the screen
when SNMP Mode is either
v1-v2-v3
or
v3_only
.
NOTE:
For more SNMP information, see
“NOTES ON SNMP”
on
Page 165 .
3.4.5 AP Location Push Config Menu
This menu configures the AP for updating connected remotes with the
AP Locations File loaded on the AP.
Invisible place holder
Figure 3-23. AP Location Push Config Menu
•
TFTP Host Address
—IP address of the TFTP server that holds the
AP locations file. [
any valid IP address; 0.0.0.0
]
•
Transfer Options
—Menu for configuring the TFTP transfer.