GE MDS Mercury Series, Reference Manual

Page: 55 / 196

05-4446A01, Rev. C Mercury Reference Manual 47
•
Data VLAN Subnet Config
—Presents a screen where you can view
or set the IP mode and address information (see Figure 3-17 on
Page 49 ).
•
DHCP Server Config (Data)
—Presents a screen where you can view
or set DHCP server status and address information for data
functions (see Figure 3-16 on Page 49 ).
Management VLAN
Subnet
Configuration Menu
Invisible place holder
Figure 3-14. Management VLAN Subnet Configuration Menu
NOTE:
Changes to any of the following parameters while communi-
cating over the network (LAN or over-the-air) might cause a
loss of communication with the unit you are configuring. You
must re-establish communication using the new IP address.
•
IP Address Mode
—Defines the source of the IP address of this
device. Only static IP addressing mode is available when VLAN
Status is enabled. [
Static, Dynamic; Static
]
•
Static IP Address
—The IPv4 local IP address. [
192.168.1.1
]
•
Static IP Netmask
—The IPv4 local subnet mask. This value is
used when the radio attempts to send a locally initiated message,
either from the terminal server, or from a management process.
[
255.255.0.0
]
The lower three lines of the screen (
Current IP Address
,
Current IP Netmask
,
Current IP Gateway
) show the current addressing configured at the trans-
ceiver.
Current IP Gateway
only displays on this screen if
Default Route IF
on the
Network Interface Config
menu ( Figure 3-13 on Page 46 ) is set to
Management
.
Selecting option I from the menu in Figure 3-13 on Page 46 displays the
screen shown in Figure 3-17 on Page 49 . Note that the IP address is dif-
ferent even though it is the same physical unit. This is because this IP
address is defined for a different VLAN.