GE MDS Mercury Series, Reference Manual, Page: 80 / 196

72 Mercury Reference Manual 05-4446A01, Rev. C
Invisible place holder
Figure 3-35. UDP Point-to-Point Menu
Configuring for UDP
Point-to-Point
Use UDP point-to-point configuration to send information to a single
device.
•
Status
—Enable/Disable the serial data port.
•
IP Protocol
—UDP Point-to-Point. This is the type of IP port
offered by the transceiver’s serial device server.
[
TCP, UDP; TCP
]
•
Remote IP Address
—Data received through the serial port is
sent to this IP address. To reach multiple Remotes in the net-
work, use UDP Point-to-Multipoint.
[
Any legal IP address; 0.0.0.0
]
•
Remote IP Port
—The destination IP port for data packets
received through the serial port on the transceiver.
[
1–64,000; 30010
]
•
Local IP Port
—Port number where data is received and passed
through to the serial port. The application connecting to this
transceiver must use this port number.
[
1–64,000; 30010,
]
•
Packet Redundancy Mode
—For proper operation, all radios’
Serial Packet Redundancy mode must match (Single Packet
mode vs. Packet Repeat mode). This is because a transceiver,
when in Packet Repeat mode, sends 12 extra characters
(sequence numbers, etc.) to control the delivery of the
repeated data. Misconfigurations might result in undesired
operation.
•
Data Baud Rate
—Data rate (payload) for the
COM
port, in
bits-per-second. [
1,200–115,200; 19200
]
•
Byte Format
—Formatting of data bytes. Data bits, parity and
stop bits. [
7N1, 7E1, 7O1, 8N1, 8E1, 8O1, 8N1, 7N2, 7E2, 7O2, 8N2,
8E2, 8O2; 8N1
]