September 2004
2-18
Programming Site Data
Entering KV/SS Table - KV/
SS
Use this option to calculate the kinematic viscosity (KV) based on
signal strength (SS). Complete the following steps to enter KV and
SS values:
1.
Press
[ESC]
,
[ENTER]
,
[ESC]
. The meter enters the user program.
2.
Press [
X
] until
PROG
appears and press
[ENTER]
.
3.
Press [
X
] until the desired channel appears. Press
[ENTER]
at
CH1
or
CH2
.
4.
Press [
X
] until
SETUP
appears and press
[ENTER]
.
5.
Press [
X
] until
ADVAN
appears and press
[ENTER]
.
6.
Press [
X
] until
KV/SS
appears and press
[ENTER]
.
7.
Enter the number of kinematic viscosity/sound speed pairs (2 to
20) by using the arrow keys. Press [
W
]
and [
X
] to move the
cursor to desired location and press
[
S
]
and
[
T
]
to increase or
decrease the number and press
[ENTER]
.
8.
Enter the signal strength value (50.0 to 85.0) by using the arrow
keys. Press [
W
]
and [
X
] to move the cursor to desired location
and press
[
S
]
and
[
T
]
to increase or decrease the number and
press
[ENTER]
.
IMPORTANT:
You must enter the KV vs. SS pairs in descending
order of KV and ascending order of SS. For example,
if pair 1 is KV = 10 centistokes and SS = 62, then
pair 2 must be KV
≤
10 centistokes and SS
≥
62.
9.
Enter the kinematic viscosity values (0.050 to 500) in descending
order by using the arrow keys. Press [
W
]
and [
X
] to move the
cursor to desired location and press
[
S
]
and
[
T
]
to increase or
decrease the number and press
[ENTER]
.
10.
Repeat Steps 8 and 9 for each pair.
Procedure Options
After completing the above steps, the user program returns to the
Advanced Feature
window. Do one of the following:
•
To continue regular programming, refer to Appendix A,
, to navigate to the desired menu.
•
To leave the user program, press
[ESC]
five times.
Summary of Contents for AquaTrans AT868
