GE AquaTrans AT868, User Manual

Page: 42 / 158

Programming Site Data 2-17
September 2004
Initializing Setup
Parameters - INIT
Use this option to initialize (reset) all of the parameters within the
SET
UP
menu back to their default values. Complete the following steps to
reset all of the parameters:
1.
Press
[ESC]
,
[ENTER]
,
[ESC]
. The meter enters the user program.
2.
Press [
X
] until
PROG
appears and press
[ENTER]
.
3.
Press [
X
] until the desired channel appears. Press
[ENTER]
at
CH1
or
CH2
.
4.
Press [
X
] until
SETUP
appears and press
[ENTER]
.
5.
Press [
X
] until INIT appears and press
[ENTER]
.
6.
Select
YES
or
NO
.
Procedure Options
After completing the above steps, the user program returns to the
SET UP
window. Do one of the following:
•
To continue regular programming, refer to Appendix A, Menu
Maps , to navigate to the desired menu.
•
To leave the user program, press
[ESC]
four times.
Using Advanced Features
- ADVAN
This option enables you to access the more advanced features of the
meter. In this option you can do the following:
•
KV/SS
- calculate the kinematic viscosity (KV) based on signal
strength (SS) - refer to page 2-18.
•
MULTK
- enter a table of K-factors (based on velocity or
reynolds number) that compensates for non-linear flow rates -
refer to page 2-18.
•
MASS
- enable mass flow (calculated for static fluid density) -
refer to page 2-20.
•
CODEL
- select the size of the transducer transmission signal -
refer to page 2-21.