GE AquaTrans AT868, User Manual

Page: 30 / 158

Programming Site Data 2-5
September 2004
Entering Transducer and
Pipe Parameters - CHx-
PIPE
Enter the transducer and pipe parameters via the
PIPE
submenu. While
following the programming instructions, refer to Figure A-1 on page
A-1 in Appendix A,
Menu Maps . Remember to record all
programmed data in Appendix C, Data Records .
Accessing the PIPE
Submenu
1.
Press
[ESC], [ENTER], [ESC]
. The meter enters the user program.
2.
Press [
X
] until
PROG
appears and press
[ENTER]
.
3.
Press [
X
] until the desired channel appears. Press
[ENTER]
at
CH1
or
CH2
.
4.
Press [
X
] until
PIPE
appears and press
[ENTER]
.
5.
Do one of the following:
•
Standard transducers, enter the transducer number by using the
arrow keys. Press [
W
]
and [
X
] to move the cursor to desired
location and press
[
S
]
and
[
T
]
to increase or decrease the
number and press
[ENTER]
. Proceed to the next step.
•
Special transducers, proceed to Special Transducers below.
IMPORTANT:
Special transducers have no engraved number on the
head and are rarely used. Examine the transducer
head carefully for a number.
6.
Go to one of the following sections:
•
Standard clamp-on transducers - proceed to Pipe Material on
page 2-7.
•
Standard wetted transducers - proceed to Pipe Outside
Diameter on page 2-8.