GCC Technologies RX II Series, User Manual

Page: 28 / 229

RX II Series User Manual
Installation 2-15
2.6.3 Extension Holder Installation
Extension holder is used to move the center of a cutting blade from the original position.
The extension holder needs to be installed to the carriage, then insert the blade holder
into the extension holder. Plase follow the step by step instruction below.
Step 1
Remove the case from the carriage.
Step 2
Insert the screw into the hole on the extension holder, and then fasten the case to the
carriage. Please note the flange of the holder extension must put into the grooves of
carriage.
Extension holder
Screw Extension holder