GCC Technologies RX II Series, User Manual

Page: 109 / 229

RX II series User Manual
Automatic-Aligning System
5-10
Step 4 Load the printout onto cutter
■ The Origin Mark is is different from the rest registration marks. Please make sure the
media is fed with correct direction.
Step 5 Cut the Contour
■ Send out the command from software to perform the contour cutting job.
5.6 Tips for AAS
For getting better results of contour cutting, there are some tips below for your reference.

Keep light sources simple and avoid illuminating from the sides of cutter.

Before operating AAS, change the maximum paper size in RX II series driver
property.
Step 1 Find the RX II model
in the “Printer & Fax” folder of your PC.
Step 2 Open the Properties window
and select the “Paper” tab.
Step 3 Change the maximum Paper Size of X to 1200 mm.

Adjust the cutting speed to between 300~600mm/sec.

Avoid the registration marks locating on the tracks of pinch rollers.

Make sure the edge of the media is not bent up when detecting registration marks.