Puma III User Manual
Operation 4-10
To activate the Die Cut function, go to “Option”, tick “Die Cut”, and enter the amount you wish
for the “Length” and “Force” of both Die Cut and Kiss Cut, then click “OK” (see figure 3).
When the job is completed and you untick the Die Cut function, you will be able to adjust the
pen speed, pen force, and offset in the section on the top following normal operating procedures
(see figure 4).
Note:
The length setting for the
cutting line of Die Cut is in the
range of 0-2000mm whereas
that of Kiss Cut is 0-100mm.
Figure 3
Note:
the extension of the
blade has to be set to cut
through both the top layer
and the backing in the very
beginning. You then adjust
the tool force for the best
cutting performance.
Figure 4
Summary of Contents for P3-132S
