GCC Technologies P3-132S, User Manual

Page: 55 / 179

Puma III User Manual
The Control Panel 3-7
parameters includes Speed, Force, Offset, Up Speed, Quality
and Scaling though the latter three will not be displayed in this
section. To adjust or check individual parameters, go back to
the responding keys on the panel and press “Enter” to
confirm.
Set Smoothing
Cut To enable smooth-cutting function. Enable
Over Cut To generate an overcut to facilitate weeding. 0.00mm-1.00mm
0.05mm/per step 0.00mm
Set Tangential
Mode To enable the emulated tangential-cutting mode for thicker
media types and small letter cuts.
Note: while the Offset value setting at 0.000 mm, “Set
Tangential Mode” will automatically be disabled. Disable
Panel Setup Accept setup command:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Restore
Default To turn all parameters of the menu items to factory-default
settings.
[ MISC ]
Auto Unrolled
Media To avoid paper jam and motor crash by automatically unroll
media (50cm and up) before cutting while enabled. .
* Auto-unroll only effects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
Enable
Rear Paper
Sensor To detect if the rear paper sensor is covered to determine the
following process; when it is enabled, the cutter will detect if
the material has covered the rear paper sensor under the Roll
and Edge mode; when disabled, the rear paper sensor will
not be functioning.
Note: Rear paper sensor only functions under “Roll” and
“Edge” mode.
Enable
Disable Enable
Vacuum To help improve tracking and cutting accuracy by turning on
the fans. If you turn off the vacuum system, the fans
will remain inactive during cutting or plotting. Enable
First Back to
Origin
To enable the carriage back to the previous origin; when
“Enable” is selected, the carriage will not go back to the
previous origin while the selection of “Disable” allows the
carriage to do so.
Enable
Disable Enable
AAS Offset To set or modify AAS offset value.
You can refer to “5.3 Printer Test” for more details.
Paper Saving
Mode To save media by four different modes:
1. Length expanded mode 2. Width expanded mode
3. Both expanded mode 4. Both unexpanded mode Length
expande
d mode
Set
Communication
To build up the communication between host computer and
cutter.
Baud Rate is to determine the speed of data transmission.
Data Bits refers to the size of one block of data.
Parity is used to check if data was revived correctly or not.
9600, n, 7, 1, p 9600pbs, 7 Bits with NO Parity
9600, o, 7, 1, p 9600pbs, 7 Bits with ODD Parity