GCC Technologies P3-132S, User Manual

Page: 65 / 179

Puma III User Manual
Operation 4-9
• LOAD: This function allows you to load previously saved print driver parameters.
• ORIGINAL: This function will load the print driver’s original factory parameter settings.
• SAVE TO DEFAULT: This function allows you to save your current print driver parameters as
the default startup settings.
• DELETE: This function will delete the file you select from the Custom Media section, whereas
the settings in Default section cannot be deleted. Please note the delete function only
removes the list shown in Custom Media section, it does not remove the file from your hard
drive, if you wish to completely remove the file from your hard disk, you will have to manually
delete the file from your operating system.
Die Cut
The Die Cut function must be activated with the Kiss Cut function to avoid the falling of
cut-through materials and material jam beneath the carriage. Die Cut helps you to cut through
the backing of the material while Kiss Cut cuts through only the top layer but not the backing.
This will leave only tiny bits of the backing attached to the top layer, creating complete individual
patterns with backing sheets (see figure 1 and 2).
Cutting line
Vinyl
Figure 2
Figure 1