GCC Technologies LaserPro Venus II, User Manual

Page: 28 / 118

- 28 - 232001280G(13)
of GCC laser is normal, it should be something wrong in the LAN environment , ask
the administrator of the LAN to solve the problem.
3.2 Graphics Software Setup
The LaserPro VENUS is compatible with graphics software that can output HPGL commands,
such as CorelDraw, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software

Photoshop

CorelDraw

Illustrator

AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro VENUS, but
these are not supported. Any software that can output to the LaserPro Print Driver should work.
3.2.1 Recommended Computer Configuration
The LaserPro VENUS operates under Windows operating systems and is designed to work on
a computer that meets the following minimum requirements.
Computer

CPU Pentium 90 (or equivalent) or greater

RAM 32MB or higher

HDD 1.2 GB Hard Drive or greater

SVGA
15” Super VGA Monitor

On Board Parallel Mode (Enabled from your motherboard’s BIOS):

SPP
– Preferred Mode

ECP
– Cable (Less than 1.8 meters)
Software

The LaserPro VENUS drivers are designed for Windows 7, or newer operating systems.
NOTE
Support will not be offered, if you experience output problems with non-supported
graphics software.