GCC Technologies LaserPro C180II, User Manual

Page: 36 / 141

232001840G(06)
4.2 Graphics Software Setup
The LaserPro C180II is compatible with graphics software that can output HPGL commands,
such as CorelDraw, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software
• Photoshop
•
CorelDRAW
• Illustrator
• AutoCAD
y AutoCAD Inventor
Other software such as EngraveLab and PhotoGrav may work with the LaserPro C180II, but LaserPro
does not guarantee 100% compatibility for those software and will not provide technical support for them.
4.2.1 Recommended Computer Configuration
The LaserPro C180II operates under Windows operating systems and is designed to work on a
computer that meets the following minimum requirements.
Computer Compatibility
• CPU – Pentium 90 (or equivalent) or greater
• RAM – 32MB or higher
• HDD – 1.2 GB Hard Drive or greater
• SVGA – 15" Super VGA Monitor
• On Board Parallel Mode (Enabled from your motherboard’s BIOS):
• SPP – Preferred Mode
• ECP – Cable (Less than 1.8 meters)
Software Compatibility
• The LaserPro C180II drivers are designed for Windows Vista, 7, 8, or newer operating systems.
TIP
When you have the mass cutting production, we will suggest that you can select AutoCAD to
work with the LaserPro C180II to have better output performance.
NOTE
Support will not be offered, if you experience output problems with non-supported
graphics software.