GCC Technologies LaserPro C180II, User Manual

Page: 132 / 141

132 232001840G(08)
8.3 Cleaning the Optics System
8.3.1 Removing the Mirrors
We recommend you check the mirrors once or twice a week to see if they require cleaning. If
any debris or smoke residue is present, use the following steps to clean them.
NOTE
• It is highly recommended you remove, clean and replace each mirror one at a time!
• Refer to section 8.3.2 on how to clean the mirrors.
The following section will detail how to access and remove each of the four mirrors found on the
LaserPro C180II for cleaning.
Mirror 1
This mirror is located inside the bottom cover of the LaserPro C180II.
1) Use a Screwdriver to remove the back cover located on the bottom side of the LaserPro C180II.
2) Loosen the thumbscrew and screw to the dust cover securing the mirror. (As shown in the
picture below).
3) Clean the lens in the proper manner.
4) Re-install the mirror after cleaning.
5) Tighten the thumbscrew and screw
6) Replace and secure the outer access panel.