84
NOTE
It is good advice to place the filter basket, splash shield and re-usable filter (when
you plan to use it again) back into the filter holder and engage the filter holder
under the brewing head of the appliance. This is the best way for avoiding loss
and damage.
4. After shut-off (operating panel gets dark, only the on/off button is illuminated),
wait at least 15 minutes until the base plate cooled down. Then wipe the base
plate using a soft damp cloth to remove any stains of coffee and lime.
5. After emptying the steel carafe, rinse the steel carafe and carafe lid with clear
tap water.
6. Additionally you should perform a thorough cleaning procedure of the parts of
the coffee machine regularly (see: ‘Care and Cleaning’).
SOLVING PROBLEMS
If any problems occur during operation, you will find solutions in this section.
Problem
Possible Reason
The Solution
Emergency stop required?
Unplug the power plug from the power outlet.
When filling the water
tank, water runs out and/
or accumulates below the
appliance.
You attempted to overfill
the water tank.
Immediately unplug the appliance and wipe off spilled
water carefully. The capacity of the water tank is adapted
to the capacity of the steel carafe. Do not fill in more
than 8 cups (max. 1.0 litre). Surplus water runs out at
the overflow opening at the rear of the appliance.
You spilled some water
while filling the water
tank.
Avoid spilling water. Pour the water slowly into the water
tank. When the vessel used for filling is really full or
insufficient for this purpose, water could run down at the
exterior of the vessel.
The water tank is leaking. Immediately unplug the appliance. Contact your vendor
for examination and repair.
The time is flashing on the
display.
The clock has not yet
been set, after connec-
ting the appliance to the
power supply.
This is normal. If required, set the clock via the hour and
minute buttons. However, this is not mandatory, if you do
not wish to use the timer.
