Garudan GPS/F-1006 Series, User Programming Manual, Page: 52 / 114

Input of Pattern
48
①
Select Mirror Point
In the interface of the code list, select mirror point
(Code 005) to activate the interface in
right.
②
Set Mirror Point
In the right interface, press and input the
mirror point at the present needle position, then the
system will return to the standard interface.
After user inputs mirror point in the Position 5 of
the picture below, the system will perform the jump
feed from origin to position 3, and then carry out the
linear sewing in order of 3
→ 4 → 5(reversal) → 6 → 7 → 3.
Attention:
1. The mirror clamp of the start sewing is at left,
therefore the mirror order in later shall be the
repetition of right and left. By the way, the number
of the inputted mirror order shall be odd number. If
it is inputted at even number, the clamp may crash
to the needle at the finish, thus may cause the
breakage of needle.
2. No mirror point can be set in the following
positions:
(a) The first position after the 2
nd
origin.
(b) The first position after thread-trimming
(10) Setting of Upper Thread Tension (014)
Set the value of the upper thread tension. This value will keep valid until there is a position for the next thread
tension setting order.
www.garudan.cz