Pilot’s Guide for the Cirrus SR2x with Cirrus Perspective by Garmin
190-00820-11 Rev. A
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
708
APPENDIX B
UPDATING TERRAIN, FLITECHARTS, AND CHARTVIEW DATABASES
1)
With system power OFF, remove the Supplemental Data Card from the bottom card slot of the MFD and both
PFDs.
2)
Copy the updated terrain database to both Supplemental Data Cards. Copy the updated FliteCharts or ChartView
database to one Supplemental Data Card.
3)
Insert the updated Supplemental Data Cards into the bottom card slot of the MFD and PFDs. The Supplemental
Data Card containing the FliteCharts or ChartView database is inserted in the MFD.
4)
Apply power to the system, check that the databases are initialized and displayed on the Power-Up Page (Figure
B-10). A ‘Verifying’ message may be seen. If this message is present, wait for the system to finish loading
before proceeding to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the
ENT
Key or the right most softkey.
6)
Turn the large
FMS
Knob to select the AUX Page group on the MFD.
7)
Turn the small
FMS
Knob to select the System Status Page.
8)
Press the Display Database Selection Softkey to show database information for each display (
MFD1 DB, PFD1
DB,
or
PFD2 DB
). Verify the correct database cycle information is shown for each database for each display.
9)
Remove power from the system.
MAGNETIC FIELD VARIATION DATABASE UPDATE
A copy of the current magnetic field variation database (MV DB) is included with the navigation database.
At startup, the system compares this version of the MV DB with that presently being used by each AHRS
(GRS1 and optional GRS2). If the system determines the MV DB needs to be updated, a prompt is displayed
on the Navigation Map Page, similar to Figure B-12. Note, in the following example, GRS1 is the first AHRS
to indicate an update is available. In actuality, this is dependent on which AHRS is the first to report status
to the system. GRS2 may be displayed before GRS1. The order is not important, only that each AHRS be
updated, if more than one is installed.
Figure B-12 GRS1 Magnetic Field Variation Database Update Prompt
Loading the magnetic field variation database update (single or dual AHRS):
1)
With ‘OK’ highlighted, as seen in Figure B-12, press the
ENT
Key on the MFD. A progress monitor is displayed
as shown in Figure B-13.
