190-00709-05 Rev. D
Garmin G1000 Pilot’s Guide for the Socata TBM 850/900
503
AUTOMATIC FLIGHT CONTROL SYSTEM
7.2 FLIGHT DIRECTOR OPERATION
The flight director function provides pitch and roll commands to the AFCS and displays them on the PFDs.
With the flight director active, the aircraft can be hand-flown to follow the path shown by the Command Bars.
Maximum commanded pitch (-15°, +25°) and roll (25°) angles, vertical acceleration, and roll rate are limited to
values established during AFCS certification. The flight director also provides commands to the autopilot.
ACTIVATING THE FLIGHT DIRECTOR
An initial press of a key listed in Table 7-1 (when the flight director is not active) activates the pilot-side flight
director in the listed modes. The flight director may be turned off and the Command Bars removed from the
displays by pressing the
FD
Key again. The
FD
Key is disabled when the autopilot is engaged.
Control Pressed
Modes Selected
Lateral
Vertical
FD
Key
Roll Hold (default)
ROL
Pitch Hold (default)
PIT
AP
Key
Roll Hold (default)
ROL
Pitch Hold (default)
PIT
CWS
Button
Roll Hold (default)
ROL
Pitch Hold (default)
PIT
GA
Switch
Takeoff (on ground)
Go Around (in air)
TO
GA
Takeoff (on ground)
Go Around (in air)
TO
GA
ALT
Key
Roll Hold (default)
ROL
Altitude Hold
ALT
VS
Key
Roll Hold (default)
ROL
Vertical Speed
VS
VNV
Key
Roll Hold (default)
ROL Vertical Path Tracking* VPTH
NAV
Key
Navigation**
GPS
VOR
LOC
Pitch Hold (default)
PIT
BC
Key
Backcourse***
BC
Pitch Hold (default)
PIT
APR
Key
Approach**
GPS
VOR
LOC
Pitch Hold (default)
PIT
HDG
Key
Heading Select
HDG
Pitch Hold (default)
PIT
*Valid VNV flight plan must be entered before
VNV
Key press activates flight director.
**The selected navigation receiver must have a valid VOR or LOC signal or active GPS
course before
NAV
or
APR
Key press activates flight director.
***The selected navigation receiver must have a valid LOC signal before
BC
Key press
activates flight director.
Table 7-1 Flight Director Activation
