USER GUIDE
EdgeSafe 10G Modular Bypass | Firmware Rev Level: 0.3.3.2
6.4 Active Bypass mode
When heartbeat active mode is set to OFF the IBS stops sending the heartbeats packets,
the Active Bypass circuitry can be controlled manually to be set to one of the following
modes Normal (Inline), Active Bypass, TAP, TAPI12, TAPA, TAPAI1, TAPAI2, TAPAI12 or
Linkdrop.
In order to check the current mode of the Active bypass circuitry use the command
“show_bypass_mode” In order to change set the Active bypass circuitry use the command “
set_bypass_mode”.
Examples:
6.5 Power off state (pwoff_status)
The IBS supports Disconnect or Bypass mode at power off. When in Disconnect, in any
event of power off the IBS will be in Disconnect mode - simulates switch / router cable
disconnection on the two network ports. When in Bypass, in any event of power off the IBS
Garland Technology | 716.242.8500 |
31