27
double beep
. Then, a short beep will
be heard indicating CTC-1052RV is
now in
Learning Mode
. The
RED
LED
begins to flash.
Step 4.
Move the device to your desirable
location in the house, and press the
TEST button
to observe the range for
its operation.
Step 5.
If CTC-1052RV responds with
one
long beep
, then the particular device
is within the operation range.
<
<
N
N
O
O
T
T
E
E
>
>
For Talking Pendant WTRV:
During Walk
Test, when the Pendant button is pressed
you will hear WTRV emit beep (1s-on / 1s-
off). After about 3 sec, the Control Panel
will emit a long beep. About 2 sec later, the
Control Panel will emit a long beep again,
indicating the Pendant is within the
operating range. If you do not hear beeps
emitted by Control panel, turn the Pedant
off and repeat the steps mentioned above
until you hear the Panel beeps.
Step 6.
To exit Learning Mode, press both
RESET
&
HELP
buttons
simultaneously.
Or, CTC-1052RV will exit Learning
mode automatically after 5 mins of
inactivity.
4.5. Global Test
z
Global Test is used to test if the complete
system is working properly.
To do the Global Test:
Step 1.
Press the
RESET
button once.
Step 2. Within 5 secs
, press Pendant
button.
Step 3.
CTC-1052RV will emit a short
beep and report to Monitoring
Center.
<
<
N
N
O
O
T
T
E
E
>
>
)
This function is for WTR only, not for
WTRV.
4.6. Factory Reset
CTC-1052RV will clear all programmed
parameters by the following sequence:
Step 1.
Unplug the power cord from the DC
Jack.
Step 2.
Remove the Battery Switch rubber
cap.
Step 3.
Use a pen or screw-driver to slide the
Battery Switch to OFF position (or the
opposite direction of the ON marking)
Step 4.
Plug the power cord into the DC jack
while holding down both the
HELP
&
RESET
buttons, until one
long beep
is heard, indicating that the Factory
Reset is successful.
Step 6.
Release both buttons
Step 7.
Slide the Battery Switch back to ON
position again.
Step 8.
Replace the Battery Switch rubber
cap.
<
<
N
N
O
O
T
T
E
E
>
>
)
Once the
Fatory Reset
is executed, all
the programmed data is returned to its
default value and all the devices that
have been learnt-in are removed. You
will have to do the programming and
learn-in the devices one-by-one again.
Summary of Contents for CTC-1052RV
Page 1: ...E1 MAR 30 2011...
