Gardsman CTC-1052RV, User Manual

Page: 25 / 39

22
Remote Program and send in this format:
“ PROG 1111 REPLA: 886&0”
Where:
PROG = SMS Keyword
1111 = Access Code
REPLA = SMS command for Country
Code
886 = number to be replaced
0 = number to substitute
After this is completed, Country Code “886”
will be replaced by “0”.
4.2. Alarm Activation
z When an alarm is triggered, CTC-
1052RV will enter the Guard Time
Delay period (see Command 42), both
RED LED and RED HELP BUTTON
backlight turn on steadily.
„ During the Guard Time period,
pressing the RESET button on CTC-
1052RV, it will cancel the alarm
signal and return to Idle Mode.
„ If the Guard Time Delay is set as 00 ,
CTC-1052RV will dial immediately.
z The Alarm reporting cannot be
cancelled by pressing the RESET
button on CTC-1052RV after the
Guard Time Delay expires.
z The first alarm reporting priority is
GPRS Reporting Method.
z Press and hold the WTRV’s button for
5-8 seconds to terminate alarm
reporting, instead of the
RESET
button on CTC-1052RV.
Confirmation Beeps
z Once Guard Time Delay expires,
CTC-1052RV will summon help based
on the programmed reporting method.
A continuous confirmation beeping
sound (about 2 secs per beep) will be
heard after CTC-1052RV dials out, to
inform you that the call is in progress
(regardlss of Digital or Speech
Reporting Method).
z Confirmation beeps will be heard in
the following situations:
„ After CTC-1052RV dials out to
summom help until kiss off (for Digital
Reporting Method)
„ After CTC-1052RV dials out to
summom help until the call is
answered (for Speech Reporting
Method)
„ When first reporting failed, and CTC-
1052RV retries
z Once the first reporting succeeded,
and CTC-1052RV is in progress of
back-up reporting, the confirmation
beeps will not be heard.
1. WTRV TRIGGER
Press the Active button on WTRV to
trigger it. Then you will hear WTRV’s
confirming beeps and the beeps will stop
until WTRV receives a DTMF command. If
WTRV receives a DTMF command, it
indicates that the connection is setup
successfully. While the WTRV is triggered,
1052RV’s Help Button and Red button will
lighten until connection ends.
<
<
N
N
O
O
T
T
E
E
>
>
)
When WTRV reporting successfully
goes through to CMS, but if no DTMF
command is received by WTRV, after
2.5 minutes, connection will timeout
and WTRV will stop beeping.
)
When reporting to CMS fails, WTRV
will go to retry cycle and its confirming
beeps will continue until it receives a
DTMF command or until a retry cycle
2
.
WTRB TRIGGER
Press the Active button on WTRB to
trigger WTRB. WTRB won’t emit confirm
beeps. And 1052RV’s Help button and
Red LED will lighten.