16
* Communication Channel: 1 digit (1: Talk, 2: Two-way)
* Be sure to put * between communication channel value
and speaker volume value.
z
To set the speaker volume with a number,
ranging 1 to 15. The higher the value, the
louder the voice. Factory default is set as
(9) for Talk Only mode and set as (3) for
Two-Way mode.
z
Please refer to programming command
table (p.34) for configuration.
z
Example: if you want to raise the speaker
volume to level 7 in the talk-only mode,
please enter: 1*7
<
<
N
N
O
O
T
T
E
E
>
>
)
The volume value in the Listen mode is
set as maximum and can not be
changed.
)
Echo volume varies depending on
adjustment of speaker volume and
microphone sensitivity. To minimize
the impact of echo, if you raise
speaker volume, please be sure to
lower microphone sensitivity, and vice
versa.
)
If the two-way communication is open
after an alarm triggered by WTRV,
please note that you can not adjust
the speaker volume.
Command 64
Microphone Sensitivity Adjustment
z
This function is used to adjust microphone
sensitivity. The microphone sensibility only
can be adjusted in the two-way mode.
z
To set the microphone sensitivity with a
number, ranging 1 to 9. This value
represents the received sound source
range. The higher the value, the wider
range of sound source. Factory default is
set as (4).
z
Please refer to programming command
table (p.34) for configuration.
<
<
N
N
O
O
T
T
E
E
>
>
)
The volume in the Listen mode is set
as maximum and can not be changed
)
Echo volume varies depending on
adjustment of speaker volume and
microphone sensitivity. To minimize
the impact of echo, if you raise
speaker volume, please be sure to
lower microphone sensitivity, and vice
versa.
)
If the two-way communication is open
after an alarm triggered by WTRV,
please note that you can not adjust
the microphone sensivity.
Command 80-84
Remove Devices
z
CTC-1052RV can be programmed to
remove
ALL
previously learnt devices by
entering (
80
) followed by (
＃
). The system
will emit an acknowledging beep over the
phone for the user.
z
Command (
81
) is used to remove
Pendant
# 1 (learnt-in by Command 91)
z
Command (
82
) is used to remove
Pendant
# 2 (learnt-in by Command 92)
.
z
Command (
83
) is used to remove
Silent
Wrist
(learnt-in by Command 93)
.
z
Command (
84
) is used to remove
Other
Devices (learnt-in by Command 94)
.
<
<
N
N
O
O
T
T
E
E
>
>
)
Power Switches are not to be removed
by any Command. They are to be
removed by clearning their own
memory. Please refer to the Power
Switch’s manual to proceed.
Command 91
Learn-In Pendant #1
<
<
N
N
O
O
T
T
E
E
>
>
)
This command is not available in
Remote Programming Mode.
z
Only one Pendant can be learnt into CTC-
1052RV by using Command #91.
z
For learning
Pendant #1
:
Step 1:
Enter
91
+
#
on the phone set, then
Summary of Contents for CTC-1052RV
Page 1: ...E1 MAR 30 2011...
