![background image](http://html1.mh-extra.com/html/gardner-denver/gd-pilot-ts/gd-pilot-ts_original-operating-instructions_3574465024.webp)
8
Starting and
Operating
Gardner Denver
24
8 Starting and Operating
Fig. 22 The GD Pilot TS control panel
1. Touchscreen Display – Overview & Menu Access
2. Start Button – Starts the compressor
3. Stop Button – Stops the compressor
4. Red
LED
(Flashing slowly) – Warning
(Flashing rapidly) – Fault
5. Yellow
LED
(Flashing slowly) – Maintenance required
6. Green
LED
(Steady) – Compressor running
(flashing) – Compressor in stand-by mode
7. Emergency stop button
Danger
When the system is in stand-by mode, i.e. the green
LED is flashing, the compressor can start
automatically at any time.
8.1
Stopping the Compressor in an
Emergency
Caution
Use this method of stopping the machine in an
emergency only, as damage to the compressor
could result.
1) Press the Emergency Stop button located beside
the GD Pilot TS control panel.
8.2
Starting the compressor
Note
Every time the fault
E400 Power Supply Failure
is active/displayed, the controller performs a LED test.
The compressor can only be started when all faults
present are removed and confirmed or reset in the
Fault History
Menu.
The first text line of the display should show
Ready To
Start
.
1) Press the Start button to start the compressor.
The compressor will then start, unless any of the start
inhibits detailed below apply.
SM 1763_GD
7
1
2
3
4
5
6
L
GD PILOT TS