TM
Base Load Sequencing (BLS) 10
January 2015
USA
61 /80
Symbol Meaning
Base Load Sequencing
is switched off.
All compressors run, independently of
each other, according to their individual
settings.
Base Load Sequencing
is switched on.
Base Load Sequencing
is switched on
and is controlled by the timer control.
An alarm is displayed in the "
Base Load
Sequencing
" menu.
Chart 10-4: Symbols on the <
Base Load Sequencing
>
tab
"
Base Load Sequencing
" menu
If the <
Base Load Sequencing
> tab is active, the
"
Base Load Sequencing (BLS)
" menu can be called
up by pressing it.
If the "
Base Load Sequencing (BLS)
" menu is
called up before slave compressors have been de-
fined or the BLS function is switched off, a corre-
sponding message is displayed.
Base Load Sequencing (BLS)
On-Load
BLS is switched on.
Settings
Switched off
Standby
Compressor 1
Compressor 2
Compressor 3
Compressor 4
On-Load
Next sequence transfer in 24h.
Base Load Sequencing (BLS) is
out of service, because there
OK
are not yet defined any
participants (Slave).
Fig. 10-2: Message "
No participants (slaves) have been
defined yet
"
Base Load Sequencing (BLS)
On-Load
BLS is switched on.
Settings
Switched off
Standby
Compressor 1
Compressor 2
Compressor 3
Compressor 4
On-Load
Next sequence transfer in 24h.
Base Load Sequencing (BLS) is
switched off.
OK
Fig. 10-3: Message "
BLS function is switched off
"
1
Press the <
OK
> button to confirm the message.
– The message is closed.
– The "
Base Load Sequencing (BLS)
" menu
appears.
Base Load Sequencing (BLS)
On-Load
BLS is switched on.
Settings
Switched off
Standby
Compressor 1
Compressor 2
Compressor 3
Compressor 4
On-Load
Next change in sequence in 24 h.
1
1
2
3
4
5
1
6
7
1
Sequence:
Fig. 10-4: Typical "
Base Load Sequencing (BLS)
" menu
view
[1]
<Compressor> buttons
[2]
Volumetric flow rate
[3]
Sequence and Status Display
[4]
Network pressure
[5]
Pressure band
[6]
<Settings> button
[7]
BLS status information
The example above shows a Base Load Sequenc-
ing group that consists of the master ("
Compres-
sor 1
") and three slaves.
[1] <
Compressor
> buttons
1.3
1.2
1.4
1.1
1.6
1.5
On-Load
Compressor 1
Fig. 10-5: <
Compressor
> button
[1.1]
RS485 Address
[1.2]
Compressor Name
[1.3]
Hours Run
[1.4]
Hours Run (BLS)
[1.5]
Compressor status message (see the
chapter "Compressor Status Messages")
[1.6]
Percentage of current compressed air flow
rate (see the chapter "Compressor Status
Messages")
Summary of Contents for GD PILOT TS Series
Page 78: ...TM 78 80 USA January 2015...
Page 79: ...TM January 2015 USA 79 80...