TM
Configuration
5
January 2015
USA
37 /80
✓
The address has been set.
– The "
Communication
" menu appears.
Set baud rate
1
Press the <
Baud Rate
> button.
– The input menu for setting the baud rate ap-
pears.
2
Press the <
Baud Rate
> button for the desired
value.
The <
Cancel
> button can be used to cancel the
input of the baud rate. The previously active
setting is used.
3
Press the <
OK
> button.
✓
The baud rate has been set.
– The "
Communication
" menu appears.
5.4.6
Setting the automatic restart after
power loss
DANGER
In this Operating Mode, the compressor
can start up automatically at any time.
➯
Post warning signs on the compres-
sor.
➯
Keep the compressor room locked.
➯
Instruct the personnel.
➯
Install a main disconnect switch per
EN 60204 and post a warning sign
on it.
5.4.6.1 Auto. Restart Enabled
The controller can be set so that the compressor
starts up again automatically after a power loss.
The permissible duration of a power loss can be
set. If the power loss lasts for longer than the set
period of time, the compressor will not automati-
cally start again. The fault message "
E400:Power
Supply Failure
" appears in the display. In this
case, the compressor must be started manually.
If a compressed air station comprises several
compressors, a staged start-up can be set up by
assigning start-up delays.
Activate automatic restarting
1
Press the register card <
Settings
>.
2
Press the <
Control...
> button.
3
Press the <Arrow Key> until the <
Auto. Restart
Enabled
> button appears.
4
Press the <
Auto. Restart Enabled
> button.
– The "
Auto. Restart Enabled
" input menu ap-
pears.
5
Press the <
On
> button.
The <
Cancel
> button can be used to cancel the
enabling of the automatic restart. The previ-
ously active setting is used.
6
Press the <
OK
> button.
✓
Automatic restart after power loss is activated.
– The "
Control
" menu is displayed.
– The <
Auto. Restart Enabled
> button now
shows "
On
".
– The "
Home
" menu also shows that auto-
matic restarting is activated.
The <
Off
> button in the "
Auto. Restart Enabled
"
menu can deactivate the automatic restart again.
Setting the maximum downtime
1
Press the register card <
Settings
>.
2
Press the <
Control...
> button.
3
Press the <Arrow Key> until the <
- Max. down-
time
> button appears.
4
Press the <
- Max. downtime
> button.
– The "
- Max. downtime
" input menu appears.
5
Press the <Number Keys> to set the desired
maximum downtime.
The <
Cancel
> button can be used to cancel
setting of the maximum downtime. The previ-
ously active setting is used.
6
Press the <
OK
> button.
✓
The maximum downtime has been set.
– The "
Control
" menu is displayed.
– The time setting now appears on the <
-
Max. downtime
> button.
NOTE
The downtime can be set to "
Unlimited
". This is
not permitted in some countries. Consult Gard-
ner Denver.
Summary of Contents for GD PILOT TS Series
Page 78: ...TM 78 80 USA January 2015...
Page 79: ...TM January 2015 USA 79 80...