TM
Base Load Sequencing (BLS) 10
January 2015
USA
63 /80
Messages that are displayed if a compressor
is not available
If a compressor is not available, this is indicated
by a flashing alarm symbol on the <
Base Load Se-
quencing
> tab.
Message
Meaning
No Communication
Communication with the
slave cannot currently
be established.
Fault
There is a fault at the
compressor.
Switched off
1)
The compressor is
switched off and there-
fore not available.
Incorrect configuration
The Base Load
Sequencing configura-
tion indicates that there
are no RS slaves con-
nected. The slave, how-
ever, is a RS compres-
sor.
or
The Base Load
Sequencing configura-
tion indicates that there
are RS slaves con-
nected. The slave, how-
ever is a FS compres-
sor.
Not compatible
1)
The slave is not com-
patible. Slave compres-
sor controller or soft-
ware version is/are not
supported.
Chart 10-7: Compressor status messages
1)
Not shown for slaves that are controlled by
a compressor module (STD).
10.5
Compressor Settings and
Information
"
Compressor / Select a Setting
" menu
Calling Up
1
Press the <
Base Load Sequencing
> tab.
2
Press the <
Compressor x
> button for the de-
sired compressor.
– The "
Compressor / Select a Setting
" menu
appears.
Description
Compressor Name
Hours Run
Hours Run (BLS)
Maximum Volume Flow
Line Pressure
Select a Setting
Compressor 1
OK
Software Version
Compressor 1
Fig. 10-7: "
Compressor / Select a Setting
" menu (exam-
ple
RS
)
NOTE
Depending on the controller and type of com-
pressor (RS or FS) there are differences in the
assignment of the buttons. See the following de-
scriptions.
Compressor Name
The compressor name can be modified as re-
quired.
Modifying the name of the compressor in the
Base Load Sequencing group
1
Press the <
Base Load Sequencing
> tab.
2
Press the <
Compressor
> button of the desired
compressor.
3
Press the <
Compressor Name
> button.
– The screen keyboard appears.
4
Press <Screen buttons> to enter the desired
compressor name.
5
The <Back> button can be used to make cor-
rections.
The <
Cancel
> button can be used to cancel
the changes being made to the compressor
name. The previously active compressor name
is used.
6
Press the <
OK
> button.
✓
The name of the compressor is now changed.
– The "
Compressor
" menu appears.
– The compressor name that was entered ap-
pears on the <
Compressor
> button.
Hours Run
Indication of the actual (hours run) for the com-
pressor.
Summary of Contents for GD PILOT TS Series
Page 78: ...TM 78 80 USA January 2015...
Page 79: ...TM January 2015 USA 79 80...