TM
Safety requirements
2
January 2015
USA
5 /80
Safety symbol
Meaning
Use / Behaviour
Do not operate with open
doors or loose enclosure
panels.
It is not permitted to run the compressor with open doors
or loose enclosure panels, except for test runs. High
sound pressure level, risk of injury!
Normal operation requires the enclosure to be closed.
Do not breathe in the
compressed air from this
unit
It is not permitted to use the compressed air produced by
this compressor for breathing. Indrawn materials can be
dangerous to health.
Do not use compressed air as breathing air.
Electrical voltage
Warning against dangerous electrical voltage.
Work on the electrical equipment of the compressor may
be done only by an electrician in accordance with electri-
cal rules.
System continues to run After pressing the stop button <O>, the compressor runs
on for 30 seconds.
Do not open the compressor enclosure until the com-
pressor has stopped.
Follow the operating
instructions
Identification of instructions where additional information
can be found in the (manufacturer’s) operating instruc-
tions.
Before the device is operated, the user (operator) must
have read and understood the operating instructions
(manufacturer’s operating instructions).
Use hearing protection
Identification of areas with increased sound pressure
level.
Enter the area only with suitable hearing protection.
Warning against indus-
trial trucks
Warning of industrial trucks traveling within the plant
(e.g., forklifts).
Do not perform any work in traffic lanes with limited visi-
bility that are not secured or blocked off. Use or crossing
of this traffic lane requires great caution.
Warning of suspended
loads
Warning of suspended loads being transported.
During transport, no person may be present in the haz-
ard area. In particular, do not reach in or allow the feet to
pass beneath the suspended compressor.
Warning of moving
machine parts.
When performing maintenance work, it is necessary to
check some functions with the enclosure open. Risk of
injury due to rotational or translational motion.
Maintenance work may be performed only by specially
trained technicians.
Chart 2-1: Safety symbol
Summary of Contents for GD PILOT TS Series
Page 78: ...TM 78 80 USA January 2015...
Page 79: ...TM January 2015 USA 79 80...