TM
Configuration
5
January 2015
USA
31 /80
2
Press <
Program Inputs/Outputs
> button.
– The "
Program Inputs/Outputs
" menu ap-
pears.
Input 1
Select a Setting
OK
Programmable Inputs and Outputs
Free
Input 2
Free
Input 3
Free
Input 4
Free
Input 5
Free
Fig. 5-20: "
Program Inputs/Outputs
" menu
3
<Press the
Arrow Key
> until the desired output
appears.
Input 5
Output 1
Output 2
Output 3
Output 4
Select a Setting
OK
Programmable Inputs and Outputs
Free
Off
Off
Off
Off
Fig. 5-21: "
Program Inputs/Outputs
" menu
4
Press the <
Output x
> button for the desired
output.
– The "
Program Inputs/Outputs
" menu ap-
pears for the selected output.
Service
Warning/Service
Warn./Service/Fault
Ready for Rem. Start
Request for Start
Pressure Band p2
Timer Control
Off
Motor Running
Operating
On-Load
Off-Load
Fault
Warning
Output 1
Programmable Inputs and Outputs
Cancel
OK
Fig. 5-22: "
Program Inputs/Outputs
" menu for Output 1
5
Press the <button> for the desired output func-
tion.
The <
Cancel
> button can be used to cancel the
selection of the output function. The function
previously assigned to the output is used.
6
Press the <
OK
> button.
✓
The output has been programmed.
The other free outputs can be programmed in the
same way.
5.4.3
Timer Control
5.4.3.1 Starting and Stopping with Timer
Control
The controller can be programmed so that the
compressor is automatically started and stopped
at certain times.
Three steps are necessary for this:
1. Define the switch-on and switch-off times.
2. Enable Timer Control mode in the "
Controls
"
menu.
3. Press the Start button < I > (start up the com-
pressor).
Example
A plant works two shifts, with the day shift starting
at 8:00 a.m. and ending at 4:00 p.m.
The late shift starts at 5:00 p.m. and ends at 1:00
a.m.
The work week is 5 days; no work is done on
weekends.
Program the controller as follows:
•
The compressor starts at 7:50 a.m.
•
The compressor stops at 4:10 p.m.
•
The compressor starts at 4:50:00 PM a.m.
•
The compressor stops at 1:10 p.m.
Summary of Contents for GD PILOT TS Series
Page 78: ...TM 78 80 USA January 2015...
Page 79: ...TM January 2015 USA 79 80...