![background image](http://html1.mh-extra.com/html/ganz/nr4hl/nr4hl_user-manual_3428330058.webp)
58
System Setting
Click
<DETAIL INFO>
to view the details of the
remote control and keyboard controller.
- NORMAL : The disk is in a normal state.
- CHECK : The disk has an error so that you
need to check the disk or the connection cables
of the disk. If you leave the problem unresolved,
no recording may be enabled.
So it is recommended that you replace the disk
immediately.
- ERROR : The disk fails or is unable to use due
to an error of the disk or the cable. The disk
should be replaced immediately. Contact the retailer or the customer service to replace
the disk.
S.M.A.R.T CHECK INTERVAL : Specify the S.M.A.R.T check interval.
Click
<CHECK NOW>
to start checking.
3. To apply the change, click
<APPLY>
in the bottom of the screen.
4. When done, press the
[EXIT]
button on the remote control or click
<CLOSE>
in the low
er screen. The confirmation message appears and you will return to the previous menu.
Event Setup
Define various events, and specify the conditions to notify the user in various ways.
Alarm Out
Specify the alarm output conditions with the work schedule.
Alarm Out
1. From
<SYSTEM SETUP> - <EVENT>
, select
<ALARM OUT>
.
2. Use the
[▲▼
◀▶
/ENTER]
buttons on the
remote control or use the mouse to select
<ALARM OUT>
and configure the related settings.
>NAME : You can rename the alarm.
>OPERATION : Set the alarm output mode.
- N/O (Normal Open) : It normally stays Open.
However, if an event occurs, it will switch to Close.
- N/C (Normal Close) : It normally stays Close.
However, if an event occurs, it will switch to Open.
>DURATION : Specify the duration of the alarm output.
- TRANSPARENT : Keep the alarm out for as much time as the event lasts.
- UNTIL KEY : Keep the alarm out until a mouse or remote control button is pressed.
- 5 ~ 300 SEC : Keep the alarm out for as long as specified.
>TEST : Forcibly output the alarm for the test purpose.
3. To apply the change, click
<APPLY>
in the bottom of the screen.
4. When done, press the
[EXIT]
button on the remote control or click
<CLOSE
> in the lower
screen. The confirmation message appears and you will return to the previous menu.