GAT ECO.Lock 7xxx F/ISO
Installation
www.gantner.com
HB_GAT-ECOLock-7xxxFISO--EN_12
25
3.10 Door Handle Installation (Optional)
The optional
“GAT Lock Door Handle” (Part No. 610217, see also "2.4. System Components") can be mounted onto
the locker door to assist door opening. There is space on the door handle for a number label.
The door handle is installed over the button of the GAT ECO.Lock 7xxx F/ISO using four screws
1. GAT Lock Door Handle
4. Mounting screws (Ø 3.5 mm sheet metal screws)
2. Door outer side blind hole (4x)
5. Locker door
3. Door inner side mounting screw hole (4x)
Figure 3.12
– Installation of the GAT Lock Door Handle (dimensions in mm, inches in brackets)
Complete the following steps to install the GAT Lock Door Handle:
► On the door outer side, drill 4 blind holes (2), diameter 8 mm and depth 9 mm, around the lock button hole
according to the measurements in Figure 3.12.
► On the door inner side, drill 4 countersunk holes for the mounting screws. These holes must be located
centrally in the blind holes.
► Insert the GAT Lock Door Handle into the drilled holes on the door outer side.
► Fasten the GAT Lock Door Handle with the mounting screws (Ø 3.5 mm sheet metal screws).
NOTE!
The screw length (L) must be 2 mm shorter than the door thickness.
► If desired, a label with the locker number can be attached to the GAT Lock Door
Handle (see example). The label can be printed with a customer-specific
number, font, and color. The dimensions of the label are 37.7 x 15.7 mm, corner
radius 1 mm (1.48´´ x 0.62´´, corner radius 0.04´´).
Please contact GANTNER Electronic GmbH or your sales partner to organize
label printing.
