GAT ECO.Lock 7xxx F/ISO
Installation
www.gantner.com
HB_GAT-ECOLock-7xxxFISO--EN_12
23
When the GAT ECO.Lock 7xxx F/ISO is mounted on a double-wall metallic door, it can be mounted directly onto the
door.
Figure 3.10
– Installation of the GAT ECO.Lock 7xxx F/ISO on a double-wall metallic door
NOTE!
The door leaf thickness (see previous diagram) must not exceed 20 mm (0.79´´). Thicker doors can reduce
the reading range especially with larger data carriers, e.g., cards, so that they can no longer be read reliably.
3.8.3 Installation Instructions for Metallic Doors
Complete the following steps to install the GAT ECO.Lock 7xxx F/ISO into lockers with metallic doors.
► Mark out and drill 1 hole into the locker door for the lock button. Position the button hole according to the
measurements in Figure 3.8 and Figure 3.5 (for right-hinged doors) or Figure 3.6 (for left-hinged doors).
► Mark out 4 mounting holes on the inside of the locker door for the lock housing. Position the holes according to
the measurements in Figure 3.8 and Figure 3.5 (for right-hinged doors) or Figure 3.6 (for left-hinged doors).
► If you are also using the optional GAT Lock Door Handle, this must be installed before the GAT ECO.Lock 7xxx
F/ISO. See "3.10 Door Handle Installation (Optional)" for more information.
► Mount the GAT ECO.Lock 7xxx F/ISO onto the inside locker door using 4 screws. Use the correct screws
according to the type of locker material, max. Ø 5 mm (0.2´´). The maximum allowed tightening torque of the
screws is 2 Nm (1.47 lb-ft).
► Attach the door label(s) to the door front as shown in section “3.9 Attaching the Door Labels”.
Testing
► Check that there is no pressure applied to the button shaft of the GAT ECO.Lock 7xxx F/ISO in its assembled
state, e.g., by a part of the locker door, as this could lead to malfunction.
► Ensure that the lock button is centrally aligned in the drill hole.
► Ensure that the GAT ECO.Lock 7xxx F/ISO housing does not contact the inside of the locker body when
opening/closing the locker door.
► Ensure that the battery cover can open and is not hindered by other components.
See section “4 START-UP” for instructions on inserting the batteries and putting the GAT ECO.Lock 7xxx F/ISO
into operation.
