GAT ECO.Lock 7xxx F/ISO
Installation
www.gantner.com
HB_GAT-ECOLock-7xxxFISO--EN_12
19
3.7.2 Measurements for the Button Drill Hole
NOTE!
A
During installation, it is important to ensure that the GAT ECO.Lock 7xxx F/ISO does not brush against the locker
body when the locker door is opened. The distance of 4 mm (0.16 inch) indicated between the lock housing and the
locker body is valid for locker doors that are wider than 240 mm (9.45´´) and with a maximum door leaf thickness of
28 mm (1.1´´). For locker doors that do not adhere to these measurements, or for doors with an unfixed pivot point
(depending on the type of hinge used), the distance between the lock and the body of the locker must be
recalculated.
NOTE!
B
To increase break-in protection, a security bolt can be installed on the locker body that inserts into the locker door
when the door is closed.
Use the following measurements to position the button drill hole depending on whether the locker door is left or
right-hinged.
Figure 3.5
– Installation measurements for right-hinged doors
Figure 3.6
– Installation measurements for left-hinged doors
